How do I connect a HP Procurve 2610 switch console port to a. Not sure about the terminal server part but you would need a serial port. The settings that. I recently bought an HP Procurve 2650. Need help setting up an HP Procurve 2650 switch via serial using Linux. Just reset the device to its factory settings.

Program De Salarizare Sal here. Although the switch is in use, we never have really configured it. So my understanding is that the 2650 must be setup via the console, it doesnt have an IP address until you set that up. Of course none of our xp laptops have a serial port, and I cannot locate my usb to serial adapter (and have not always had success with it anyway).

I did find an old windows 98 laptop, and tried to setup the hyperterminal settings as per the manual( anywhere from 1200 to 115200, 8 data, 1 stop, no parity, and flow control set at xon/xoff. Of course we cannot find the original cable, so I have to use a gender converter to connect two different serial cables between the PC and the switch. Although hyperterminal says connected, I never get a prompt, and even if I disconnect the cable it says connected, so that is aggravating. What could I try next to get this to work? Are there perhaps settings on the serial port itself that might need to be changed? Some of the options it asks to change on hyperterminal do not appear on the win 98 version, or at least I couldnt find it. Any help would be appreciated.

RE: cannot hyperterminal into HP procurve 2650 (TechnicalUser) 23 Jan 08 09:47. I personally use Teraterm which is a freebie and can be found if you google for it. Check your cable again. I have the correct HP cable in front of me and on a tester the pin layout is 1-1, 2-3,3-2,4-6,5-5,6-4,7-8,8-7,9-9 The switch should respond to 9600, 8 bits, 1 stop & no parity.

Once connected with a cable you have verified the return key needs to be hit a couple of times this should make the switch auto sense 9600 baud. The HP switch manual can be found at HP.com RE: cannot hyperterminal into HP procurve 2650 (MIS) 25 Jan 08 09:47.

AskProCurve Article Title: HP ProCurve Switch - Reset to factory defaults on ProCurve Switch 1810G series Available Part Numbers: J9449A HP ProCurve 1810G-8 Switch,J9450A HP ProCurve 1810G-24 Switch Issue Description: How do I reset factory defaults on the ProCurve Switch 1810G series? Mp3 Gamma 1 Habis Satu Tambah Satu there. Solution: When the “Clear” button is pressed with the “Reset” button, any configuration changes you may have made through the switch console, the web browser interface, and SNMP management are removed, and the factory default configuration is restored to the switch. Specific steps to execute the factory default reset on the switch are: 1.

Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on the front of the switch. Numark Cue 4.3 Serial Number. Continue to press the Clear button while releasing the Reset button.

When all three Mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear button. The switch will then complete its self test and begin operating with its configuration restored to the factory default settings. Note: After completing this procedure, there will be no password, the IP address will be returned to the default 192.168.2.10, and all configuration settings will be returned to factory defaults. Modified Date: 2009-12-06.